You are here:
Water Tanks
>
Water
Pumps >
Pressure Water Pumps
Pressure Water
Pumps
Pressure Water Pumps are available in wide range of variety. No,
power washing system can survive without a good pressure water pump
as that is the most important component of the system. Pressure
water pumps can be broadly classified as direct driven, belt driven
and gear driven pumps. The functionality of a gear driven pump and
the direct pump is nearly the same except that gearbox version comes
with gears which help you to fine-tune the ratio in order to fit the
existing motor. The motor may be powered by electricity or gas but
that does not make a difference. The two most important parameters
associated with the pressure water pumps are the flow rate of the
pump and the rated pressure of the pump. So, the pressure with which
the water would flow through the nozzle would depend on the above
mentioned parameters. So, while purchasing a pressure water pump you
must pay attention to the above mentioned parameters.
The above mentioned parameters are also very important from the
point of view of the power washing system as they help in
determining the speed at which the cleaning job would be carried
out. Faster execution of the job would require lot of water at good
flow rate. The requirements of different applications is different,
therefore before purchasing a pump you must carefully analyze your
requirement. It is important to select a pump that would fit well in
line with your requirement.
In case of direct drive water pumps, the pump is directly
mounted on the engine so you would notice that a shaft would be
directly connected in order to control the operation of the pump.
The direct drive pressure water pumps are cheaper in cost and can be
installed easily without any hassle. However there is one
disadvantage of this system and it is the fact that direct drive
pressure water pumps are prone thermal wear and tear and these pumps
can be a noisy and may also vibrate a lot.
A belt driven pressure water pump is definitely much more
expensive than the direct driven version. It is comparatively much
more difficult to install because as there are more components that
are required to be assembled. Another issue with belt driven version
of pressure water tanks is that the belt often requires a
replacement but still there are many advantages of installing this
type of pressure water pump. These pumps do not create any noise
while operating. The vibrations too are very less at the time when
the pump is operating. The engines of these pumps last long as
compared to direct driven pressure water pumps and the efficiency
and productivity of these pumps is also good.
water pumps -
bianco pumps -
grundfos pumps -
onga pumps -
dab pumps -
davey pumps -
pressure water pumps -
solar water pumps -
water tank pumps -
hotwater pumps -
Call Rainwater Tanks Direct to help you choose the best rainwater pump for your home.
Call Now on 1300 88 94 90
or e mail us at
info@rainwatertanksdirect.com.au
Next Article:
Solar Water Pumps
|
